How fast will Nano Energizer takes effect?
Diesel vehicles: from 500km and fully coated at 2,000km Petrol vehicles: from 500km and fully coated at 1,500km Motorcycle (below 650cc): from 100km and fully coated at 1,000km NGV vehicles: from 100km and fully coated at 1,000km Is Nano Energizer guaranteed to perform? Yes. Nano Energizer has been extensively tested by various testing facilities, car manufacturer and individuals. To date, all of results are positive and proven effective. Do read the testimonials and endorsement. Where and when can I use Nano Energizer? Nano Energizer can be added directly into the engine right after an engine oil change or 2,000km before the next oil change schedule. Do I need to reapply Nano Energizer after each oil change? No. You just need to ensure that Nano Energizer has completed its coating cycle before you replace the engine oil. You only need to reapplyNano Energizer after every 30,000km to maintain optimum benefits. How much Nano Energizer should I use for my engine? One sachet (30ml) for engines with 4 to 10 litres oil capacity (most cars) or 2 to 3 sachets for bigger engine up to 25 litres oil capacity and so on. Advertisement Of Nano Energizer |
Nano Energizer is revolutionary & patented platinum coated Nano Ceramic material for engine easy restoration, repair and protection for an engine, gearbox and mechanical machine that uses lubrication. Is Nano Energizer similar to engine treatment or oil treatment? No. Engine or oil treatment basically only provide an additional layer of lubrication between the engine cylinder wall and piston for extra protection during engine operations. They do not coat or restore worn out engine cylinder. How does Nano Energizer improve fuel efficiency and combustibility? Nano Energizer contains Platinum which proven scientifically to improve combustion inside engine cylinders. Improvement in combustibility will indirectly improve fuel efficiency due to less wastages of unburned fuel. How does Nano Energizer restore & protect engine cylinders wall? The Nano Ceramic (Zirconium) coated the Platinum are 20x stronger and has a higher wear and heat resistance than a typical engine block material. Nano Energizer bonds to cracked or worn engine wall through heat and pressure. Where can I apply Nano Energizer? Any type of petrol, diesel or LPG based engines (cars, motorcycles, trucks, busses etc), generators, gearboxes or any mechanical that uses oil for lubrication. How to apply Nano Energizer?
1.Warm up engine for 3~5 minutes if the engine is in cold condition. 2.Switch off the engine. 3.Shake well Nano-Energizer (about 1~2 minutes) to ensure the content material are evenly dispersed in the sachet. 4.Open oil filter cap and pour the whole content into engine. 5.Close oil filter cap. Warm up engine or drive your vehicle for 10~20 minutes to let the Nano Energizer evenly spread in the engine. 6.Drive your vehicle for 800-1500km for the ceramic coating to take effect. 7.Once the treatment completed, it will last up to 30,000km. 8.Repeat to use Nano-Energizer after 30,000km engine run. |
